| Last Modified: 11-29-2007 | 1.6 G | |
| Service Category: Steering | Section: Steering Column | |
| Model Year: 2008 | Model: Sequoia | Doc ID: RM00000319N003X |
| Title: STEERING COLUMN: STEERING COLUMN ASSEMBLY (for Power Tilt and Power Telescopic Steering Column): ON-VEHICLE INSPECTION (2008 Sequoia) | ||
ON-VEHICLE INSPECTION
1. REMOVE UPPER STEERING COLUMN COVER
2. REMOVE LOWER STEERING COLUMN COVER
3. INSPECT TILT MOTOR
(a) Disconnect the connector A from the multiplex tilt and telescopic ECU.
(b) Connect the positive (+) battery terminal to terminal 10 (TIM+) and the negative battery terminal to terminal 1 (TIM-) of the tilt motor connector. Then confirm that the steering wheel tilts up.
OK:
Steering wheel tilts up.
(c) Connect the negative (-) battery terminal to terminal 10 (TIM+) and the positive battery terminal to terminal 1(TIM-) of the tilt motor connector. Then confirm that the steering wheel tilts down.
OK:
Steering wheel tilts down.
4. INSPECT TELESCOPIC MOTOR
(a) Disconnect the connector B from the multiplex tilt and telescopic ECU.
(b) Connect the positive battery terminal to terminal 2 (TEM+) and the negative battery terminal to terminal 6 (TEM-) of the telescopic motor connector. Then confirm that the steering column contracts.
OK:
Steering column contracts.
(c) Connect the negative battery terminal to terminal 2 (TEM+) and the positive battery terminal to terminal 6 (TEM-) of the telescopic motor connector. Then confirm that the steering column extends.
OK:
Steering column extends.
5. INSTALL LOWER STEERING COLUMN COVER
6. INSTALL UPPER STEERING COLUMN COVER
|
|